Olivia Sliding Door May 03rd, 2018 - 13:26:27
Take out the dimensions of the dimensions where you want to get a door. Make sure that the base and sides are leveled and there is nothing coming in the way. Then take your information to a lumberyard or local home improvement association so that you have a customized door with slide mechanism. There you will have a wide variety to choose from. There are finished as well as unfinished sliding doors available. You should choose the one that is best for your home décor and matches the dimensions of your location. A track is first installed on the location of the door and it is hidden with the decorative item like wood moldings. Also purchase the equipment for installing the sliding door. After bringing the correct sized sliding door in your house.
TIMBER You can choose from a number of engineered timber folding sliding doors including softwood or hardwoods such as Meranti and European Oak. Timber is normally engineered or laminated to ensure it is structurally resistant to warping or twisting and doors are normally available with either a factory applied translucent stain or RAL colour paint finish. As timber is a natural insulator timber folding sliding doors offer the most energy efficient solution when combined with high performance double glazing offering U values as low as 1.4. Timber folding doors usually provide slim sight lines as the individual door panels are normally hinged off each other without the use of additional mullions between each panel and therefore maximising visible glass areas.
Lubricate the tracks - Apart from ensuring that the sliding door tracks and rollers are clean, you should also apply lubrication to the lower and upper tracks for a free operation. You can also lubricate the door lock using an aerosol lubricant so you can flush out grime and coat moving parts within it. You would need to disassemble the lock to lubricate it; you can have a professional do it for you if you are not very sure. Install a commercial lock - Commercial entrance sliding doors deserve a commercial lock to improve reliability and security. The lock can be used as a replacement for the latch lock or supplement for the same and can be installed at any given door height and adjusted accordingly. The locks feature two or one bolt locking systems which attach to closure points and steel bolts that drop right into place. You can also go a step further to wire an alarm system to the door.
1. Firstly take the slider door off the track and place it to the side. This many require a little muscle, but is easy enough to do. If you are unable, try turning the screws on the rollers clockwise and then lift the door from its frame. 2. Clean the track with soapy water and a wire brush. 3. Take a metal file and file down and rough spots or ridge that are sharp to the touch. 4. Measure the length of the old track. 5. Cut the new stainless steel track to this length. 6. Place the new track on the old aluminum track. It will snap over the old track and then with light dabs of glue, glue down on the threshold. 7. Lubricate the new track for smooth opening and closing 8. Remove the old rollers by removing the frame lock screw, lift frame and then remove. Now slide the new rollers into place and re-install frame lock screw. 9. Re-install the sliding door and test the opening and closing. As an additional note, it might be worth it to consider purchasing a manual retractable sliding door screen or motorized screen. This screen will allow you to keep your sliding door open in summer, but keep the bugs and insects out. These screens will retract back into their housing when not in use, but will cut down on the opening and closing of your sliding door.